QUESTIONS:
1) What is the connection Order for HDMI?
2) Why won't the set top box pass video signal through my receiver with an HDMI connection?
3) What can I do if the HDMI video will not pass through my reciever?
4) What Should I know about HDMI connections and cables?
QUESTIONS AND ANSWERS:
1) What is the connection Order for HDMI?
The connection order can be a key issue as to whether or not the HDMI signals will pass through the system. For best results the receiver should be turned on first, then the source device(s) and then the display. The reason for this has to do with getting the equipment to handshake properly for the HDCP protocol. This is a consideration when programming remote control system call keys or hot keys where everything turns on at once. You may need to consider the order of equipment turn on when programming these convenience keys.
back to top
2) Why won't the set top box pass video signal through my receiver with an HDMI connection?
A set top receiver connected to an A/V receiver via HDMI may have trouble passing video signals through the A/V receiver even though a direct connection to the display seems to work fine. This has to do with the HDMI HDCP protocol being sent and received and the authentication process. This is not a fault of the receiver. Recently set top box manufacturers have become aware of this issue. It has been found that the U-code information appears to be the problem which is part of Annex A of the repeater conformity specifications of the HDMI protocol. Some set top receiver manufacturers have already implemented firmware changes to their units while others are in the process of updating their units. If a set top receiver being used is having problems passing HDMI video signal through an A/V receiver, contact the manufacturer of the set top receiver to see if an update is available.
back to top
3) What can I do if the HDMI video will not pass through my reciever?
If HDMI video will not pass through your receiver, you may have an alternate connection method depending on the A/V receiver you have purchased. Check to see if your A/V receiver has analog to digital video conversion. If so, a component connection can be made to the A/V receiver instead for the source in question. Then by turning the analog to digital video conversion feature on in the A/V receiver, video from this source should then be available on the HDMI monitor output connector.
back to top
4) What Should I know about HDMI connections and cables?
The operation of a product by means of an HDMI connection is guaranteed only when a cable certified by the HDMI standard is used. Product performance can not be guaranteed when a cable not certified by the HDMI standard is used, as signal degradation of the high frequency digital signal can occur. This is often confused as a problem with the device rather than the cable itself. Typical performance failures from uncertified cables can include no picture, blinking (on/off) display, pixilation, sandstorm type of interference and poor quality picture. The HDMI logo is not a certification that the cable has passed the HDMI standard guaranteeing product performance.
CABLES THAT HAVE BEEN CERTIFIED BY THE HDMI STANDARD
At present, the following cables that have confirmed HDMI certification are as follows:
Manufacturer Model Name Types of Cable (length)
JAE DC1 Series 4 types: 1.5, 2, 3, and 5 meters
Radio Shack NA 3 types: 1.8, 3.6 and 4.9 meters
Sony DLC-HM Series 3 types: 1.5, 3, and 5 meters
Audio Technica ATMX Series 3 types: 1.5, 3 and 5 meters
Disclaimer:
This list is not meant to be an all inclusive list of available cables nor is it meant to promote one brand of cable over another. Denon does not endorse any one brand of cable and this is for informational purposes only. This list is subject to change without notice.
Nov/05
back to top
|
